Australia’s #1 Industrial B2B Marketplace
Pallet Racking Accessories
SpeedRack supplies a range of Pallet Racking Accessories.
Wire Mesh Decking
Wire Mesh Decking Panels sit over pallet racking beams. They have inbuilt welded support channels.
Particleboard Retainer Clips
For light applications, the board can be used unsupported being held in place using Particleboard Retainer Clips (Z clips).
Board Support Channels
For heavier applications, the use of Board Support Channels increases the carrying capacity of the board and locks the board into position.
The column guard is bolted to the floor in front of the uprights providing protection from forklifts to the bottom portion of the upright. As it is not connected to the upright it takes all impact.
Barrel Chocks are used when barrels or drums are to be stored on Pallet Racking Beams. They prevent the barrel from rolling along the beam. The Barrel chocks are fitted over the front beam or both front and rear beams, but are not fixed.
Fork Entry Bars
These are used when unsuitable pallets or unpalletised loads are to be stored on beams and handled by forklift trucks. The bars provide a gap of approximately 75mm above the beam for forks.
Pallet Support Bars
Supported at each end by the beams, Pallet Support Bars provide a secondary support member for pallet racking. The Pallet Support Bar is designed to have its top surface flush with the beams.
J – connectors
For use with Cable Racking
Beam Safety Pins
Nuts & Bolts
Row Spacer / Back Tie