Australia’s #1 Industrial B2B Marketplace
Power Analyser | 3 Phase | Lutron | DW-6095 | DW-6093
Power quality problems can cost you big money.
Power can be lost through changes in power factor through different boards in your plant, or different phases in a board. You can suffer from very high tariff rates being applied based on short term peak loading. The first step to making a decision on the best action plan, is to find out what is happening in your plant power system.
The Lutron DW-6095 provides the most functionality of all the simple power analysers with up to 35 parameters to 600VAC and 1200 amps – or 3000amps with the optional flexible current probes. It includes harmonics to 50th order and captures transient events [non graphically] as dips, swells and outage with a response time around 130microseconds. Data can be logged at intervals from 2 second to 7200 seconds with 30000 sets of 9 parameters per block, on a 2GB SD card – for ready analysis in a spread sheet.
The unit comes as a complete kit with current (x 3) and voltage probes (x 4) in a carry bag ready for use.
CP-3000 flexible current probes for 30, 300, and 3000amp [selectable] are optional for the DW-6095 and connect directly without separate power supply.
For a lower cost solution there is model DW-6093 that has no Phase graphics and no transient detection. It has the same capability for measurements and logging
The information gained through a plant-wide review with this instrument will guide you in planning steps to reduce your power consumption, and certainly your power bills in future. For more information contact ECEFast.
Click here for further information about the Lutron DW-6095
Click here for further information about the DW6092 and LU-DW6093