Australia's #1 industrial directory for equipment & suppliers

AUS - Correlux P-1

Supplier: Advanced Utility Solutions

The correlator Correlux P1 is used for leak location on pipes for potable water. Water, escaping a leak under pressure, creates a noise which travels into both directions of the pipe. This noise is recorded by two sensors attached to the pipe (e.g. valves, hydrants), amplified and transmitted to the correlator. The Correlux P-1 compares both signals (correlation) and calculates the exact distance to the leak from the signal delay, the sensor distance and the sound velocity


Easy to use

  • Simple operation with rotary encoder
  • Rugged and compact
  • Large, high-contrast ? VGA display with optimal visibility in any light condition
  • <500 mW radio power for great range, even out of line of sight
  • Transmitter with headphone connection to listen to the leak noise. Graphic and numeric level display for faster pre-location
  • Possibility to charge the entire system within the transport case via mains adaptor or car adaptor. Direct charging or operation via headphone socket
  • Optimised antenna and sensor connection-no disassembly necessary for transport
    Extensive list of accessories


Salient Features

  • Simultaneous display of the correlation trace and the coherence spectrum (FFT analysis).
  • Quick filter optimisation without the use of menus
  • Automatic and manual filter adjustment 0 ... 4000 Hz
  • Autocorrelation for leak location on dead ends
  • Possibility of measurements on mixed pipe materials with up to 6 pipe sections
  • Velocity measurement for unknown pipe materials
  • Optimised display of the correlation trace to safely analyse leaks. Continuous measurement and averaging
  • Active piezo ceramic accelerometers, best suited for plastic pipes
  • Internal trace memory and PC software for hardcopy and archiving Software updates via RS 232 interface