Australia's #1 industrial directory for equipment & suppliers

Seed Drill | Drillrite | H300

Supplier: PFG Australia

Main frame is a fully welded structure, consisting of three staggered beams and end plates.


Main frame

  • Fully welded structure, consisting of three staggered beams and end plates
  • 75x75x6mm beams
  • Beams are not butt welded but run through end plates for added strength and avoiding twisting and weld fatigue
  • Fully galvanised
  • Long service life
  • Higher resell value
  • End plates are designed to carrying the hoppers, the gearboxes and the working platform
  • End plates have integrated tow down provisions and hooks, e.g. to pull a set of harrows

Row spacing Two options

  • 150mm (6Inch), 3.0m working width with 20 runs (Model H300-20)
  • Unique 100mm (4Inch), 3.0m working width with 29 runs (Model H300-29)

Seed and fertiliser hoppers

  • 580L capacity each
  • Weather proof lid fitted with gas struts
    • Easy access to the complete width of the seed and fertiliser box
    • Easy filling/cleaning
  • Quality powder coat finish
    • Long service life
    • Higher resell value 


  • Unique patent design
  • Tine with assister spring
  • Slim design allows 100mm row spacing
  • Angled slightly forwards
    • Allows seed tube to be below soil level in work position
  • Tungsten tip suited for most soil conditions
    • Fixed via single roll pin

Fertiliser metering system

  • Driven via separate variable speed gear box
  • Simple, reliable nylon fluted metering roller system
  • Quick release outlets
    • Quick and easy cleaning of the fertiliser hopper

Sowing depth adjustment

  • Via donut spacers on lift cylinder
    • Simple and fast adjustment of sowing depth
  • Levelling of drill via draw bar support
    • Ratchet type turnbuckle
    • Quick and easy levelling of the drill
    • Drawbar can be folded to reduce storage room

Optional cutting coulter

  • Ideal for over-sowing of existing grassland or paddock with surface trash
  • Lower and raised from tractor cab, via double acting hydraulic cylinder
  • 13.5" waved disc coulters
  • Triple lip seal bearings
  • Spring loaded protection

Fully equipped drill

  • Full road light kit
    • LED rear lights with lens protection device
    • Side lights
    • Rear mounted hazard panels
  • Working platform with hand rail and folding step
  • Swivel drawbar eye
  • Jack stand
  • Electronic hectare meter
  • Electronic scales and calibration trays

Gear boxes for seed and fertiliser metering

  • Variable speed gearbox
  • Quick change sprockets for low and high ratio
    • No tools required
  • Allows seed rates of about 1Kg (small seeds) to 300Kg (large seeds)

Drive and sprocket

  • Use of hex drive shafts where possible
    • No need to use sprockets with keyway or roll pins
    • No need for bearings with grub screw or locking collars etc
    • Less risk of drive line failures

Seed metering system

  • Fully enclosed sponge feed system
    • Eliminates damage by rodents or birds
    • Avoids seed spillage by wind
    • Handles a large range of seeds, including grass, clover, peas, maize etc
    • Very gentle on seed
    • Seed output unaffected by vibrations
  • In hopper seed agitator standard
    • Can easily be removed if required
  • Seed calibration
    • Simple lowering of seed tube holder (8 rows)
    • Install provided calibration trays
    • Operate gearbox via supplied handle