Softing - 10Gb/s Network Cable / WiFi tester NetXpert XG SE

Supplier: Ti2 Pty Ltd

10Gb/s Copper & Fibre, PoE, WiFi

35 Recent Views In Stock

Compare

10Gb/s Network Cable / WiFi tester NetXpert XG SE

NetXpert determines the cable length and the distance to faults performing full TDR (Time Domain Reflectometer) measurement in combination with a capacitance measurement, for increased accuracy.

Description
The new NetXpert XG verifies, if cabling channels support maximum transmission rates of up to 10Gb/s, irrespective of the category of cables, patch panels, or outlets installed. NetXpert XG provides a precise statement by automatically performing three individual tests which are combined into an overall test result.

New standards defining data rates up to 10Gb/s are a big challenge for the qualifiers of the latest generation. Particularly cabling for wireless access points has to support the ever increasing data rates. In order to verify if the cabling installed is able to support the increased data rates, operators need to perform adequate testing before commissioning the network, to avoid any unpleasant surprises. NetXpert XG enables you to meet the new challenges now!

Technical features at a glance

Tests data cabling for IEEE 802.3 compliance at data rates
of up to 10 Gb/s (BERT)
Determines signal-to-noise ratio (SNR)
Measures delay skew
Combined length measurement performing TDR and capacitance measurements for highly accurate test results and easier troubleshooting even of shorts
Full-color wire map shows opens, shorts, miswires, and split pairs in a clear and easy to understand way
Saves test results and generates standards-based measurement reports providing „Pass/Fail“

Network and Diagnostics

Supports IPv4 and IPv6
Discover your network and see the connected network devices
Identifies defective PoE switches with a PoE load test
DHCP test
Ping lists can be defined and saved for later use
LLDP/CDP detection and analysis
Identifies VLANs present in your network
Data transfer from the tester to the PC using USB stick

Need more information? Message Ti2 Pty Ltd via the form, or call and say you found them on IndustrySearch so they can best assist you.

Technical features at a glance

Tests data cabling for IEEE 802.3 compliance at data rates
of up to 10 Gb/s (BERT)
Determines signal-to-noise ratio (SNR)
Measures delay skew
Combined length measurement performing TDR and capacitance measurements for highly accurate test results and easier troubleshooting even of shorts
Full-color wire map shows opens, shorts, miswires, and split pairs in a clear and easy to understand way
Saves test results and generates standards-based measurement reports providing „Pass/Fail“

Network and Diagnostics

Supports IPv4 and IPv6
Discover your network and see the connected network devices
Identifies defective PoE switches with a PoE load test
DHCP test
Ping lists can be defined and saved for later use
LLDP/CDP detection and analysis
Identifies VLANs present in your network
Data transfer from the tester to the PC using USB stick

Read less...

Need more information? Message Ti2 Pty Ltd via the form, or call and say you found them on IndustrySearch so they can best assist you.

Supplier

Ti2 Pty Ltd

Call 1300 842 1..

Get a Callback from an expert

Distribution: Australia and New Zealand Only

Location: Rhodes, NSW

Customers: Cochlear, Nanosonics

Trade With Confidence. The supplier of this item is approved as a Verified Supplier. Business registration, contact details and locations have been verified. Ti2 Pty Ltd are also proudly displaying these credentials:

Established:

2001

Employees:

1-5

Customers:

Cochlear, Nanosonics

Memberships:

Profibus & Profinet Association

Certifications:

CE, EN50155, MIL, IEC 61131-3

Distribution:

Australia and New Zealand Only