125mm sink swaging with NP-2 Hydraulic Hole Punch

Supplier: Stainelec Hydraulic Equipment
10 September, 2013

Stainelec Hydraulic Equipment has the solution for installation of 125mm commercial strainer wastes.

Stainelec Hydraulic Equipment now has the solution for easy installation of the largest strainer waste at 125mm diameter to suit commercial sink bowls. The 125mm swaging die, complete with 125mm punch and die set can be used in production and for existing on-site bowls which require an upgrade to a new 125mm strainer waste. Many existing commercial catering kitchens are fitted with 50mm wastes and in some instances with 90mm size waste.
To meet the new regulatory food laws the strainer waste basket system prevents users from discharging food wastes into the drainage systems. The 125mm strainer waste system is ideal for high volume commercial kitchens requiring greater capacity within the scrap trap. Available from Stainelec, model NP-2 hydraulic hole puncher unit is used to punch out the 125mm hole size and a special swaging die has been designed to install the recess for the 125mm strainer to fit correctly after the 50mm waste hole is punched out to 90mm diameter.
Fitting of the scrap waste sink strainers is now easy to install within a few minutes. Two series of the waste sink strainers are available from the 3 Monkeezs, original plastic body with stainless strainer and basket and the full stainless steel body in 304 or 316 grade stainless steel material. Model NP-2 will also accept the 90mm punch and die as well as the swaging die for the 90mm strainer wastes.

Stainelec 125mm Sink Bowl Swaging Demonstration for Scrap Traps