AirChaser Dustcontrol Concrete, Tile and Stone Dust Shroud for Grinder
A more effective way to control dust from it's source when cutting, chasing, repairing and cleaning out joints, cracks, tile cleaning, and cutting works onsite. Meet the Air Chaser - a dustless shroud for angle grinders.
Description
Applications for this product
Stone
Marble
Tiles
Concrete
Remedial concrete and Repair works
Features of this product
Adjustable cutting depth - up to 12mm
Full view of the cutting zone
Effective design keeps the cutting blades cool
Adjustable for ALL Angel Grinders
Patented Design
Weighs only 450g !
Instructions (comes with diagram on packaging of this shroud to make for easy fitting)
Install the first blade on the bearing flange, screw the long nut, install the second plate and tighten it with the flange nut in the way the flange nut was, then centre the second blade. Make sure that hte blades are fixed properly. While using two blades the load on the angle grinder is increased.
Close the standard cover of the angle grinder with the Device by bracing it to the toes.
Set the grips on the pins of the cover clasping the standard cover of the angle grinder.
Tight the grips on the pins of the cover clasping the standard cover of the angle grinder.
Tight the rips with the fly-nuts providing the symmetry of the Device to the blade.
Fixaction of the cutting depth levelis performed by the fly nut.
The vent-pipe of the Device is to be connected directly to the sprag hose of the vacuum cleaning. then the Angle Grinder is ready to work - DUST FREE.
*Using 2 blades with this device increases load on the angle grinder. Avoid overheating and overload of your angle grinder unit during use.
Need more information? Message All Preparation Equipment via the form, or call and say you found them on IndustrySearch so they can best assist you.
Applications for this product
Stone
Marble
Tiles
Concrete
Remedial concrete and Repair works
Features of this product
Adjustable cutting depth - up to 12mm
Full view of the cutting zone
Effective design keeps the cutting blades cool
Adjustable for ALL Angel Grinders
Patented Design
Weighs only 450g !
Instructions (comes with diagram on packaging of this shroud to make for easy fitting)
Install the first blade on the bearing flange, screw the long nut, install the second plate and tighten it with the flange nut in the way the flange nut was, then centre the second blade. Make sure that hte blades are fixed properly. While using two blades the load on the angle grinder is increased.
Close the standard cover of the angle grinder with the Device by bracing it to the toes.
Set the grips on the pins of the cover clasping the standard cover of the angle grinder.
Tight the grips on the pins of the cover clasping the standard cover of the angle grinder.
Tight the rips with the fly-nuts providing the symmetry of the Device to the blade.
Fixaction of the cutting depth levelis performed by the fly nut.
The vent-pipe of the Device is to be connected directly to the sprag hose of the vacuum cleaning. then the Angle Grinder is ready to work - DUST FREE.
*Using 2 blades with this device increases load on the angle grinder. Avoid overheating and overload of your angle grinder unit during use.