Wika - Differential Pressure Transmitter DPT-10

The DPT-10 differential pressure transmitter has been introduced to fill the gap at the high-value end of WIKA’s product portfolio for electronic differential pressure measurement. It is  now possible
to offer a WIKA differential pressure transmitter without having to revert to a 3rd-party product.
In the development of the DPT-10 the foremost requirements were simplicity of operation, an extensive range of cases for fitting to a very wide array of applications and a good price/performance
ratio.

Available Pressure ranges (Differential pressures) for max. static operating pressure 160 bar:

0 … 10 mbar to 0 … 40 bar
for max. static operating pressure 420 bar:
0 … 500 mbar to 0 … 40 bar
Units mbar/bar, kPa/MPa, psi
Output signals 4 … 20 mA, 4 … 20 mA HART,
PROFIBUS PA, FOUNDATION Fieldbus
Electrical connections M20 x 1.5 cable gland,
alternatively ½‘‘ NPT Conduit
Pressure connections
- ¼-18 NPT (IEC 61518)
- RC ¼
- Various threaded adapters and valve blocks
- Diaphragm seal connection
Accuracy 0.075 % of span
Ex approvals to ATEX, IEC, Gost
Explosion protection types:
- intrinsic safety
- flameproof enclosure
Full Details available on Data Sheet PE 86.21 (www.wika.com.au)

A wide range of case variants are available, for fitting in the wide variety of installation situations:

Case materials:
o Plastic
o Aluminium
o Stainless steel, deep-drawn, electropolished
o Stainless steel, cast
Case designs:
Single chamber case Double chamber case Case mounted remotely via cable
Target markets:
- Chemical Industry
- Oil & Gas industry
- Pharmaceutical industry
- Food & Beverage industry
- Tank and vessel construction
- Plant construction
Applications:
- Monitoring of pumps and filters
- Level measurement in open and pressure-blanketed tanks
- Density measurement and separation layer measurement in tanks
- Flow measurement using primary flow elements (standard orifice plates, pitot tubes, Venturi tubes).