XP2i gauges are rated in percent of reading, like deadweight testers. Accuracy is 0.1% of reading down to 20% of the range. Pressure ranges available are 0-15 PSI, 0-30 PSI, 0-100 PSI, 0-300 PSI, 0-500 PSI, 0-1K PSI, 0-2K PSI, 0-3K PSI, 0-5K PSI and 0-10K PSI. All have 316 stainless steel wetted parts. Absolute pressure version available for gauges 2000 PSI and above.
Pressure units available for display by selection of the units button are PSI, kPa, kg/cm2, inch H2O, mm Hg, bar + mbar. Gauges are temperature compensated from -10 to +50 Degrees celsius.
Can also be supplied with a diaphragm seal fitted when the process medium contains solids that may clog the pressure inlet. Fitment of a diaphragm seal may result in a slight variation to the stated 0.1% accuracy.
The XP2i can also be upgraded with DataLoggerXP firmware where you can record up to 6000 pressure measurements into non-volatile flash memory. The recording interval can be set to a minimum of 1 second to a maximum of 18 hours.
Dual Line Display - adds a second line to the display which can be set to indicate peaks, average, leak rate or the difference in pressure relative to a second XP2i connected via an ordinary DB-9 null modem cable. The second XP2i can be any pressure range or model.
XP2i pressure gauges are ATEX certified and meet all the requirements set forth by the EU (European Union) for equipemnt that may be operated in potentially explosive enviroments.
Enclosure - Aluminium Alloy sealed to IP67 ratings.
Mounting - Direct mount bottom entry, direct mount rear entry or panel mount (3 hole front flange) rear entry.