CRC - Electronic Cleaning Solvent - CRC CO Contact Cleaner

Non-corrosive, non-staining, rapid complete evaporation – contains no lubricants. Removes light contaminants, dust, lint, atmospheric oils, finger prints, moisture from precision electrical/electronic equipment where lower-flashpoint solvents may be used. Leaves no residue to increased resistance. Use as a touch-up supplement for vapour degreasing. Does not contain CFC 113 or Methyl Chloroform. Deactivate equipment before use. Flammable formulation. Ventilate after use.

PHYSICAL PROPERTIES:

• Flash Point < 0°C
• Dielectric Strength 40,000 Volts/ASTM D-877
• Boiling Point 60.5°C
• Specific Gravity 0.67
• Relative evaporation rate Fast
• Residue None
• Kauri-Butanol Value 31
• Surface Tension 21 dynes/cm

Use CRC CO Contact Cleaner for cleaning:
Relays, Switches, Circuit Breakers, Alarm and Signal Systems, Printed Circuit Boards, Connectors, Generators, Contacts, Laboratory and Test Equipment, Video Heads/Drums, Terminal Plugs and Jacks.

When CO Contact Cleaner is used on lubricated rotating, sliding or stepping contacts it is recommended to apply CRC 2.26 to replace lubrication.

Pack Size for Electronic Cleaning Solvent - CRC CO Contact Cleaner

• CRC CO Contact Cleaner (Part No. 2015) - 150g Aerosol, 6 pack
• CRC CO Contact Cleaner (Part No. 2016) - 350g Aerosol, 6 pack

NZSFA Approved C12 (All Product Except Dairy)