Touch dry in an hour, Hammerite gives long-lasting protection and is suitable for use on a wide range of exterior metal including gates, railings, drainpipes, guttering and garden furniture.
Apply direct to rust
Protects for up to 5 years
No primer or undercoat required
For metal inside and outside the home
Available in smooth, satin or hammered finish
Available in 250ml, 750ml, 2.5L & 5L, 285ml aerosol
Applications - Aerosol
Store aerosol at room temperature for 2 hours prior to use. Shake can vigorously, in a vertical motion, until the agitator ball is heard and then for a further 3 minutes. Apply light even coats, from a distance of approximately 15cm (6 inches) and keep the aerosol moving. Do NOT concentrate spray in one spot. Apply 3-4 coats for maximum protection and allow 15 minutes between coats. Between coats invert can and spray for 2 seconds to avoid blockages.
Applications - Brushed
1. Ideal application temperature 8? - 25?. 2. Lightly stir before use. Do not mix vigorously. 3. Do not mix paint from 2 tins or mix colours. 4. Brush application: Do not thin. On previously painted metal in sound condition, 1 coat should be sufficient. On bare/rusty metal 2 coats are required. Ensure that all edges and corners are adequately covered. Do not over-apply as sagging will occur. 5. Coventional spray application: Thin with Hammerite Brush Cleaner & Thinners at a ratio of 15% Thinners to Paint. Set spray gun at 25/35psi and use full fan spray at maximum volume. Apply 4 thin coats. Allow 1 hour between coats. Refer to spray equipment manufacturer's guidelines for the correct and safe use of sprayers.
Cleaning and Storage After use, remove as much paint as possible from brushes before cleaning with Hammerite Brush Cleaner & Thinners.
Permanent Painted Coatings (PPC), an Australian owned and run company has been established for over 18 years in Australia.
We specialise in a range of imported and local, proven products that are ...