1000mm/s speed for engraving photo, super smooth vector cutting quality.
Control the exhaust fan,air assist, and alarm lamp automaticly, energy saving
RDWorksV8 laser software.
Set speed, power, and more directly from the LCD panel.
Help the user to set focus Easier. (based on motorized table)
Control the table up/down from LCD panel directly
Honey Comb Table
Reduces underside reflections.
Aluminum Blade Cutting Table
Reduce the influence of the reflection of laser.
Engrave high quality 3D photos directly.
Achieve “3D cutting” on some materials
High-speed Ethernet line or the USB cable line
USB Disk Interface
Thunder laser system supports the USB disk loading.
Visible Red Dot Pointer
Make the laser beam “visible”.
High Quality Laser Blue
Every laser tube must pass the strict quality control test.
High Quality Optics
High quality optics.
Thunderlaser easily re-adjusting 3D mirror mounts.
Turn off the machine immediately when there is an accident.
Open Flap Protection
Laser will stop working if you open the front cover.
Laser will stop working if the water cooling system is not working
Show the work state and tell when the job is done, more safe for you.
Standard Laser head
It is the most often used head.
Blowing air to prevent the material being burned
Low Noise Cooling Fan
Operate the laser in a quiet and comfortable surroundings.
High Quality Rails
Keep the engraving/cutting precise and very durable.
Ensure the work pieces and laser cutter machine inside be clean.
keep the temperature to ensure the stability of laser working.
Blowing air to prevent the material being burned.
Laser Tube Wattage
900x600mm(35.4″ x 23.6″)
Max Part Size (WxLxH)
Front door closed
1000x730x230mm(39.4″ x 28.7″ x9.0″)
1000x∞x20mm(39.4″ x ∞” x0.8″)
1000x730mm(39.4″ x 28.7″)
Z Axis Height
1500x1105x1040mm(59.1″ x 43.5″ x40.9″)
Sealed Co2 Glass Laser Tube
Motion Control System
High-Speed Hybrid servo motor
Speed and Power Control (engraving depth)
Computer or manually controlled speed and power from 0-100%. Vector color mapping sets speed and power settings using RGB color mapping.
Optimized raster, vector, and combined mode
User controlled from 100 to 500DPI(standard laser head), up to 1000 DPI(HR head)
Ethernet and USB Connection
Compatible Operating Systems
3.5″ LCD panel showing current file, total working time, laser power, speed etc.
110 to 240 volts, 50 or 60 Hz, single phase
Integral exhaust fan.There is 1 output port, 5.7″ (145 mm) in diameter in the rear of the case.
Thunder Laser Australia | Laser Cutter and Laser Engraver Equipment IndustrySearch Trusted Supplier
Dongguan Thunder Laser Equipment Co., Ltd. is professionally engaged in producing laser cutter and laser engraver as well as the research and development of laser control system. Thunder Laser has been ...