Home Trusted by 500,000+ buyers

Mass Flow Control Type 8701 and 8711

Supplier: Burkert Fluid Control Systems

BÜRKERT’S BYPASS MASS FLOW METER – FASTER AND MORE ACCURATE FOR INSTANTANEOUS PROCESS RESPONSE

Price Guide (Inc GST): POA

Bürkert Fluid Control Systems has launched the new Type 8701 Mass Flow Meter (MFM) and Type 8711 Mass Flow Controller (MFC) in Australasia, giving process operators faster, more accurate and more flexible system control. 

 

The modular 8701 and 8711 devices, which are available in a variety of materials for different gas characteristics, take gas flow measurement and control to a new level of accuracy with semiconductor sensor arrays built directly into device bypass ventricles.  The units are capable of dual calibration for multiprocess operation.

 

These capabilities are particularly relevant to food & beverage, environmental and water, waste stream, packaging, laboratory, medical, thin film tech, analyser, heat treatment, industrial laser industries, as well as related industries in which gas flow must be measured and controlled.

 

“Highest accuracy, longest term stability and responsiveness is the key to generating regular and repeatable process output,” said Mr Chris Hoey, Managing Director of Bürkert Fluid Control Systems.

 

“Bürkert’s new mass flow sensor technology has combined the advantages of bypass sensor systems and direct gas flow measurement, allowing extremely fast response to fluctuations in the gas pressure and gas temperature avoiding fluctuation in gas flow and consequently enhancing overall output uniformity,” he said.

 

Bürkert uses a new mass flow sensor technology that, in addition to the actual sensor, integrates analog electronics, linearisation, temperature compensation and analog to digital conversion on one single chip. To achieve this level of functionality, the Bürkert mass flow sensor is operated via a powerful microprocessor that is integrated into the fundamental controls of the devices to directly generate a digital output signal.

 

Bürkert’s Type 8701 measures gas mass flow by diverting a miniscule volume of flowing gas into a bypass channel in which the sensor is located.  Passing over the sensor, gas mass flow is measured according to the thermal principle, which has the advantage of delivering direct mass flow without correction for pressure and temperature.  Flow is read as an analog output, or digitally over RS232- or RS485-communication.

 

The semiconductor sensor element is a (semiconductor) chip located in the bypass channel.  The sensor part of the chip, produced with CMOS technology, contains a heating resistor and two temperature sensors (thermopiles) which are arranged symmetrically upstream and downstream of the heater. The differential temperature measured by thermopiles is a measure of the mass flow rate passing this bypass channel. The highly accurate 32 point calibration stimulates an unique assignment of the sensor signal to the total flow rate passing the device.  See Figure 1.

 

Bürkert’s new mass flow devices are suited to use in a stand-alone capacity, a modular system component or as a building-block in a comprehensive automation system solution.

For further information about the Mass Flow Control Type 8701 and 8711 visit Burkert Fluid Control Systems at http://www.burkert.com.au
OR
Use the IndustrySearch e-mail feature below and one of the Burkert Fluid Control Systems team will respond to your enquiry directly.

A Complete Range Of Fluid Control Products And Unique Smart System Solutions