The unit auto-zeros before each test, auto-calibrates viscosity and does not exceed 2 min and 50 sec when heating from ambient to 100ºC ± 0.3ºC. During testing the die chamber temperature will be redeemed to the tolerance of ± 0.3ºC within one minute from die closure.
Statistical Process Control Software (SPC):
Data storage: ML and MF, or any other two Mooney values
Scorch time at T5 and T35 and T18, or at any other scorch time or relaxation time and its values
Provides statistical analysis of the above stored data by X-Rm chart, X-R chart, Normal
1 x Large rotor
1 x Small rotor
2 x die cutter
2 x 2kg Calibrator
1 x Copper bar
1 x Copper brush
5 x Fuses
10 x Rubber seals
2 x Calibration certificates
1 x Operation manual
The standard model UM-2050 consists of one main testing unit and one sub-unit for control and data analysis, equipped with one PC, one colour monitor and one colour jet printer.
Temperature: (a) Working range: Ambient to 200ºC (b) Accuracy: ±0.3ºC (c) Display Resolution: 0.1ºC
Moving die frequency: 2rpm (or frequency conversion type upon request)
Mooney Unit: M (1M = 0.735 1bf-in)
Mooney display resolution: 0.01M
Mooney range: 0 – 200M (or higher upon request)
Maximum load: 250M (or higher upon request)
Scorch time: 0 – 99.9M
Rotor types: Small and Large
Pneumatic pressure: 65Psi or 4.5kg/cm2 or 0.45Mpa (Air compressor is not included)
Electricity Supply: AC 220V ±10%, 50/60Hz, 7A, Single phase, or upon user request
Measurements: Main Unit: (L)700mm x (W)590mm x (H)1240mm ; Sub Unit: (L)600mm x (W)500mm x (H)640mm
Weights:Main Unit Nett: 250kg ; Sub-Unit Nett: 40kg
Australia’s leading manufacturer & supplier of testing & measuring instruments, providing quality solutions to customers’ manufacturing process & laboratory testing requirements.
We supply a vast ...