Australia's #1 industrial directory for equipment & suppliers

Multispiral | Slider H12S

Supplier: Ryco Hydraulics

Meets or exceeds the performance requirements of SAE 100R12, AS 3791 100R12, EN 856 Type R12, EN 856 Type 4SP (-12 and above), ISO 3862 Type R12.

CONTACT THIS SUPPLIER TO FIND OUT MORE

Recommended For:
Very high pressure hydraulic oil lines, in applications where the outside cover of the hose is subject to sliding abrasion that may cause premature failure of standard hoses.
The extremely high abrasion resistant properties of the polyethylene sheathed cover, combined with the extra high working pressures and excellent impulse life when tested to SAE 100R12 test conditions result in, increased service life and minimise equipment downtime.

Tube:
Black, oil resistant synthetic rubber.

Reinforcement:
Four alternating layers of spiralled high tensile steel wire.

Cover:
Black, abrasion resistant and oil resistant rubber sheathed with a layer of extremely abrasion resistant polyethylene.
The maximum weight loss of the cover under ISO 6945 method of test for abrasion resistance is less than 0.2% (less than 0,002 g) of that allowed by DIN 20023
and EN 856.
Highly visible layline branding for easy and permanent identification.
No skiving required with T700 Series BITELOK Crimp Couplings. 
 
Temperature Range:
From -40°C to +121°C (-40°F to +250°F).
For water, emulsions etc. click here

Working Pressure:
Maximum working pressures are based on 4:1 safety factor (minimum burst to maximum working pressure).

Flame Resistance:
Complies with Flame Resistant requirements of Australian Standard AS 2660 and Method of Test AS 1180.10B.
Meets Flame Resistant Designation “U.S. MSHA” of the US Department of Labor, Mine Safety and Health Administration.

CONTACT THIS SUPPLIER TO FIND OUT MORE

Showcase your business!

Connect with 600,000 industrial buyers annually

Learn more