Brady's range of pipe marker products are designed in accordance with AS1345-1995 and enable quick recognition of pipe contents.
A successful pipe identification program helps employees, contractors and emergency responders to distinguish between pipes where there are several side by side. Pipe markers also save valuable time when tracing lines for maintenance and especially in emergency situations.
Where would pipe markers be located?
Australian Standards (AS 1345-1995) specifies that markers be placed adjacent to all junctions, valves, service appliances, bulkhead and wall penetrations. Markers shall be spaced no more than 8m apart except for long, uninterrupted straight runs of external services where spacing shall not exceed 50m.
Our sizes meet Australian Standards and are list below:
- LARGE 475x60mm – to suit pipes over 70mm diameter.
- MEDIUM 475x35mm – to suit pipes 40-70mm diameter.
- SMALL 100x200mm – to suite pipes under 40mm diameter (supplied 14 labels per sheet and are designed to be wrapped around pipes.
To request a quote for your pipe markers, use a spreadsheet similar to the table above and email it through to us. One of our friendly staff will get back to you ASAP.
Click here to see further information about this product available from Jabac