Servo Motor Tests & Checks Get latest price

Servo Motor Tests & Checks

27 Recent Views Call for more details

Typical tests and checks carried out on servo motors in our workshop:

• On entrance to the workshop, take digital photo
• Carry out testing for - resistance, insulation and inductance
• Surge test unit to prove
• Check feed back devices to manufacturers specifications
• Run motor (if possible) check against manufacturers specs
• Check bearing housings and shafts to mechanical tolerances
• Check magnets to manufacturers specs (if required)
• Quote to customer for approval to repair
• After customer approval
• Clean all parts of the motor
• Rewind Stator (if required)
• Carry out repairs to housings, shafts (if required)
• Replace all bearings and seals
• Reassemble motor
• Install feed back unit, to manufactures specifications
• Test both statically and dynamically to ensure correct operation
• Set up and calibrate resolvers, tachometers and encoders to correct signal and position
• Set brake to manufacturers holding torque settings (if applicable)
• Run test to prove motor and feed back unit
• Load test and report (if required by customer)
• Check motor to manufacturers specs and digital entrance photo
• Paint
• Final inspection and return to customer

To contact Servo Motors Australia about Servo Motor Tests & Checks use Get a quote.

Typical tests and checks carried out on servo motors in our workshop:

• On entrance to the workshop, take digital photo
• Carry out testing for - resistance, insulation and inductance
• Surge test unit to prove
• Check feed back devices to manufacturers specifications
• Run motor (if possible) check against manufacturers specs
• Check bearing housings and shafts to mechanical tolerances
• Check magnets to manufacturers specs (if required)
• Quote to customer for approval to repair
• After customer approval
• Clean all parts of the motor
• Rewind Stator (if required)
• Carry out repairs to housings, shafts (if required)
• Replace all bearings and seals
• Reassemble motor
• Install feed back unit, to manufactures specifications
• Test both statically and dynamically to ensure correct operation
• Set up and calibrate resolvers, tachometers and encoders to correct signal and position
• Set brake to manufacturers holding torque settings (if applicable)
• Run test to prove motor and feed back unit
• Load test and report (if required by customer)
• Check motor to manufacturers specs and digital entrance photo
• Paint
• Final inspection and return to customer

Read less...

To contact Servo Motors Australia about Servo Motor Tests & Checks use Get a quote.