TIG/Stick Welding Power Source - Dynasty 200 Series

Supplier: Aitken Welding Supplies

263 Recent Views Call for more details

Compare

NEW! Low OCV Stick is a simple design that reduces the open-circuit voltage to 12-16 volts when the welding power source is not in use. This built-in circuit design eliminates the need for add-on voltage reducers.

Easy installation - Auto-Line provides state-of-the-art flexibility to the end user. The Auto-Line circuitry automatically connects to 120-460 VAC, single- or three-phase power without removing the covers to relink the power source. No longer is there a concern if you have the correct machine for shop or the job site.

Advanced Squarewave arc for improved weldability on aluminum and magnesium using low power. Continuous high-frequency is NOT needed because of the advanced Squarewave arc, and extended balance control allows you to fine-tune the duration of the electrode negative portion of the cycle from 30 to 90%. This provides precise cleaning control and prolonged tungsten life.

Inverter-based, AC/DC power source has state-of-the-art operator interface allowing the user extra set-up capabilities in a compact machine. Features more precise control of output parameters.

Programmable HF start parameters allows the operator to independently set HF starting conditions based upon process or application.
HF start for non-contact arc starting that eliminates tungsten or material contamination.
Lift-Are start for TIG arc starting without the use of high frequency.
Superior arc performance even on difficult to run electrodes like E6010.

Need more information? Message Aitken Welding Supplies via the form, or call and say you found them on IndustrySearch so they can best assist you.

Inverter-based, AC/DC power source has state-of-the-art operator interface allowing the user extra set-up capabilities in a compact machine. Features more precise control of output parameters.

Programmable HF start parameters allows the operator to independently set HF starting conditions based upon process or application.
HF start for non-contact arc starting that eliminates tungsten or material contamination.
Lift-Are start for TIG arc starting without the use of high frequency.
Superior arc performance even on difficult to run electrodes like E6010.

Read less...

Need more information? Message Aitken Welding Supplies via the form, or call and say you found them on IndustrySearch so they can best assist you.