It accepts an input of 4-20mA, feedback signal of 100 to 10,000 Ohms and generates 2 independent relay contacts (ramp up/ramp down) and drives a 2 digit LED display showing valve position in percent open. The instrument operates in auto mode where it tracks the input signal or in manual mode where the actuator can be driven to any desired position.
Manual ramp up and ramp down
120 or 240VAC 47-63 Hz or 18 to 36VDCFeatures
High contrast 9mm LED display
Low cost - High performance
Panel mount enclosure
Optional 4-20mA retransmission
Applications include the control of actuators in critical loops
The VP100 is an electronic motor positioner which operates within the motor feedback circuit. It accepts an input of 4-20mA and a motor position feedback signal from a three wire potentiometer generates 2 independent relay contact outputs and displays the motor or valve position in % (percent) open.
The VP100 incorporates auto/manual transfer by front push button. In manual mode, the user is able to drive the servo motor to any desired position with the ramp up or ramp down push button, ensuring the user always has control of the motorised valve or gate position in the event of loop failure.
The instrument accepts an input signal of 0-20mA or 4-20mA with 100 Ohms input impedance and a feedback signal of 100 to 10,000 Ohms from a three (3) wire potentiometer or 4-20mA current loop.
The instrument has two output relays for motor actuator control with a contact rating of 5 amps inductive at 240VAC with an RC filter for spark suppression.
Optional 4-20mA output into 500 Ohms
A three (3) digit high contrast light emitting diode (LED) with a digit height of 10mm, a wide viewing angle and a viewing distance of 5 metres.
0-70 degrees Celsius
0-90% rh non condensing
Panel mount instrument
Rear mount 12 way terminal strip
Instrument Power Supply
120/240VAC 47-63 Hz or nominal 24VDC (12 to 36VDC).
Panel mounting: Impact resistant panel mounting plastic enclosure of case dimensions 96mm wide by 48mm high by 148mm deep with a panel cut out of 93mm wide by 45mm high.
Model/input signal/display units/power supply
All units shipped factory calibrated to 0-100
Innovec Controls | Process Instrumentation
Innovec Controls is Solutions That Work. We can offer products that will do what you want, when you want.
Whether it be counting bottles on a production line, flow measurement, a fuel gauge or a fuel interlock on a CNG Vehicle, LED lighting for trains & trams, we can supply.
We also solve unusual applications by Bespoke design to your specific requirements.
We manufacture in Australia and supply quality and reliable instrumentation to the world market.