The Westermo MCW-211 convert data between Ethernet 10/100 Base-TX and 100 Base-FX. The unit is easy to use and install caused by auto-negotiation of speed and duplex and auto-crossover and auto-polarity on 10 Mbit/s.
The media converter is be transparent for large frames (VLAN or QoS). It is also possible to set speed, duplex and flow control via DIP-switches. The FX side supports Far-End-Fault indication.
A link fault from either side shall be forwarded to the other side, Link Fault Forwarding. Via DIP-switches it is possible to control if both sides or just one (either) side supports LFF.
MCW-211 has a wide DC power input range with polarity protection and redundant power from dual sources.
With extended temperature range supported as standard the MCW-211 is designed to be used the harshest environments.
- Conversion between Ethernet 10/100Base-TX and 100Base-FX
- Transparent for large frames (QoS and VLAN)
- Galvanic isolation and enhanced surge/transient protection
- DIP-switches for:
- Speed, duplex and Auto-negotiation
- Flow control
- Link fault forward
- Auto MDI/MDI-X
- Extended temperature range –25 to +70 C
- Redundant power and wide DC input range
For further information about the Westermo Industrial Ethernet FX/TX Media Converter - MCW-211 visit Paqworks - IP Cameras at http://www.paqworks.com
Use the IndustrySearch e-mail feature below and one of the Paqworks - IP Cameras team will respond to your enquiry directly.
Solutions For Industrial Data Communications & Networking