Wide Belt Sanders - Felder FW 1102

Combination module "Standard"

• Sanding pad for fine work
• Rubber contact roller (85 shore) for calibration work

Combination module with electro-­pneumatic sanding pad

• Electro-pneumatic sanding shoe for fine work and veneer work
• Rubber contact roller (85 shore) for calibration work

Combination module with segmented-electro-pneumatic sanding pad
Segmented, electro-pneumatic sanding shoe for fine work and veneer work for various workpiece thicknesses Rubber contact roller (85 shore) for calibration work

Contact bars module and combination module

• Sanding pad for fine sanding according to your desired standard, with electro-pneumatic sanding shoe or with segmented, electro pneumatic sanding shoe
• Rubber contact roller (85 shore) for calibration work
• Combination unit with rubber contact roller (45 shore) for calibration work

Setup of the sanding unit
Adjustment of the sanding modules is quick, simple and exact. For combination modules, the pressure bar can be engaged as well as disengaged. The pressure bar height can also be adjusted in order to allow for grit compensation.
 
Sanding pad
Sanding pad for fine work
 
Belt guidance
The belt guidance system scans the workpiece using a modular spotlight and activates the electro-pneumatic belt guidance system, which moves the belt fowards and backwards. The belt control system regulates the belt movement with electronically guided photo cells. Should the belt be at risk of coming loose, the belt control system stops the belt motor immediately.
 
Perfect sanding results
Powerful motors ensure perfect sanding results. The constant power transmission onto the sanding aggregates is a significant factor in the process of producing a high quality sanding finish.
 
Feed rate
Infeed speeds of 5 and 10 m/min are available. Depending on the wood type, grain or general state of wood, the amount removed is gradually reduced as the infeed speed increases.
 
Automatic thickness measurement
The automatic thickness measurement function facilitates the desired workpiece thickness machine setting. No additional gauges are required to measure the workpiece thickness as it can be measured directly on the machine. The desired depth of cut can be pre-selected on the adjusting handwheel; + and – settings are possible.
 
Brushing equipment
As an option, on the delivery side of the machine, it is possible to set up a brushing facility. Different brushes can be inserted and their task is to clean, polish or structure the workpiece surface.
 
In and out- feed roller table (Option)
Upon request, we can equip your Felder wide belt sander with an additional roller support, both on the infeed and outfeed side of the machine.