We have the capacity to repair anything from the smallest to the largest reinforcing wire drawing block.
We offer two types of repairs:
Using our Arc Jet, we apply 420 S/S to the radius and angle, ready for grinding. This is a standard procedure used to repair most types of bull blocks
420 S/S and Tungsten Carbide: Using the above method to repair the block, we then apply a tungsten carbide hardfacing using H.V.O.F. system to further extend the life of the block. This method is used on high wearing wire drawing machines. We offer fast turnarounds at the highest possible standard.
Avweld Australasia is a design, manufacture, reclamation and maintenance engineering company specialising in thermal spraying, hardfacing and fabrication. Avweld as been in operation for over 30 years and during that time our focus has been on providing superior surfacing solutions for our clients' maintenance and breakdown requirements.
Our focus is on high wearing equipment that can benefit from either re-design or surface engineering. Not only can we repair or reclaim your equipment, we will significantly improve the life of units suffering from erosion, corrosion, abrasion and impact, or combinations of any of these.
Avweld offer a wide variety of in-house, state of the art surface engineering technologies, including: AC-HVAF, PTA, HVOF, arc spray, MIG, TIG, arc weld, flame spray and spray fuse. These processes combined with our two robotic welding cells allow us to apply coatings with exceptional accuracy to any area that requires protection.