Urschel Laboratories now offers a three-piece deep lattice knife set-up made specifically for the Urschel Model CCL Lattice Slicer. A clamp, knife blade, and knife holder make-up the three-piece knife and deliver maximum performance.
Over time, the Urschel three-piece knife also offers cost-savings over single-piece knives. Only the blade needs to be replaced with the three-piece configuration. This configuration ensures optimal cut quality and lessens the possibility of machine jamming.
Lattice slicing is a unique application. Proper feeding of the machine is necessary to ensure continuous production. Tempered high quality oval or flat shaped potatoes measuring between 51 – 102 mm are best suited and potatoes are fed into a revolving impeller assembly consisting of four rotating potato holding tubes.
The tubes allow the potato to be rotated in a vertical axis while being revolved in a radial direction. Centrifugal force holds the potatoes tightly against the inside surface of the spherical shaped slicing head. As the potatoes rotate inside the slicing head, they make an approximate one-quarter turn between each of the four crinkle knife stations. This results in intersecting crinkles on each side of the slice. Average capacity is approximately 4,000 lbs. per Hour.
There are 3 types of blades for varying lattice depths
- Fine Lattice: Translucent appearance with small lattice holes visible after frying
8 corrugations per 25.4mm
Approximately 3.2 mm peak to peak
- Coarse Lattice: Small lattice holes visible
5.7 corrugations per 25.4 mm
Approximately 4.4 mm peak to peak
- Deep Lattice: Slightly larger lattice holes
2.25 corrugations per 25.4 mm
Approximately 11.2mm peak to peak
Urschel Laboratories size reduction equipment is available exclusively in Australia and New Zealand from Heat and Control.