Conventional Rectifiers / Power Supplies

In our Rectifiers we only use "Copper" Winding Transformers for better efficiency.

In our medium to high capacity Rectifiers, Water Cooled "Copper" Busbars are used for Diode - Rectification mounting and cooling, to enable smaller construction and long life reliability.

Our Rectifiers / Power Supplies can be situated against walls as rear access is not required. Hinged doors are used on the front of our units for easy access.

Variable Output Voltage - Current is obtained by a SCR - THYRISTOR Controller or DIMMER DOT Controller. (see Variable Auto Transformer section)

Using a Dimmer Dot on three phase units inherently ensures minimal Output Ripple and Lower Electricity Demand, unlike SCR – Thyristor rectifiers.

Free standing separate oil immersed Dimmer Dots (see Variable Auto Transformer section) are available with Rectifiers higher than 15 Kw capacity for Long Life Protection.

Standard Features of the Conventional Rectifier / Power Supply

• Manual Voltage - Current Control
• Local Control with analogue meters

Conventional Rectifier / Power Supply Options Available

• Constant Voltage or Constant Current
• Remote Control
• Digital Metering
• Manual / Automatic periodic polarity Output Reversal
• Ramp up facility
• Control via Programmable Logic Controller or Computer
• Amp Hour - Minute Meters
• Choke filters for lower ripple

For further information about Conventional Rectifiers / Power Supplies visit Australian Rectifiers at http://www.australianrectifiers.com.au 
OR
Use the IndustrySearch e-mail feature below and one of the Australian Rectifiers team will respond directly.