Heavy Duty MOGGY® for Submerged Arc and Mig Welding
This Gullco unit is designed to produce precision, quality Submerged Arc or MIG welds.
SAM® Carriage, Model GM-02-295 - Friction drive heavy-duty travel Carriage, with positive chain drive on four (4) rubber tired wheels using a closed loop tack feedback for accurate speed control. Carriage controlled by the Gullco low voltage 24 volt GSP microprocessor pulse width modulation motor control, all mounted in a remote pendant control box attached to 8 ft. (243.84 cm) control cable housing the GSP control providing the forward/stop/reverse switch and infinitely variable 4-turn speed potentiometer. LED display in IPM or cm/min.
An interface cable assembly allows the Miller HDC 1500 DX to control the run/stop function of the SAM® Carriage. A manual clutch enables free wheeling. Carriage complete with a main mounting mast and handle assembly, mounting arm for one wire reel, all mounting arms equipped with quick jaw mast clamp assembly; vertical and horizontal manual 4” x 4” slides (with hardened ground rods with sleeve bearings for ease of adjustment).
Control support arm and one (1) set (two) adjustable guide roll arms. For operation on either 42/115/230 volts, single phase, 50/60 Hz AC power supply.
SAM® Carriage, Model GM-02-275 - SAM® Heavy-Duty Friction Drive Carriage for mounting customer’s supplied single sub-arc package. Carriage specifications same as model GM-02-295. No welding equipment is supplied.
GM-02-250 SAM® Heavy-Duty Friction Drive Carriage
Carriage specifications same as that of the GM-02-295, but provided with 17” x 22” (43.18 x 55.89 cm) aluminum plate providing full flat mounting surface for customer’s supplied wire feeder.
Special track and wheels available upon request.