NUMBER PLATE PROTECTOR
Allows your numberplate to be read from straight on but not from the side.
The special film decreases the visibility of the number plate as the angle increases until nothing is visible. The film does not work against red light cameras as the film is designed to work from a side angle only.
Our Number Plate Protectors are designed to defeat K and Ka photo radar cameras when the camera attempts to photograph your license plate for a "ticket in the mail".
It is very simple to install over your license plate, taking less than five minutes.
Installation is as simple as drilling some holes into the outer clear plastic for the existing numberplate screws.
Be careful not to drill too close to the film as you can permanently damage it if water gets in. The number plate protector can be installed the wrong way. Make sure that when you are directly in front of the protector, you can still clearly see through it.
If you can not then you have it around the wrong way, and the plate will work in reverse, blocking anything in front of it but nothing to the side.
When driving down the highway and pulling up behind a vehicle using license plate protectors, the entire alphanumeric characters of the license plate can easily be viewed, so patrol cars have no difficulty seeing the license plate numbers.
However, when a road side mounted camera attempts to photograph your license plate with the typical 30 degree angle from the roadside or overhead, the traffic camera can only see a white blur where the license plate numbers/letters are located.
Overhead camera protectors also available on special order.
- No "Ticket in the mail"
- No points against your driving record
The license plate protector is an inexpensive solution for photo radar traps it is available for both cars and motorbikes.
Check the local laws to ensure license plate protectors are acceptable.
To Know More about Number Plate Protector Please click here