Engine Driven Welder

Engine Driven Welder | Mine Spec 600

Supplier: Arc-i Welding Industries

Engine Driven Welder | Mine Spec 600

The Mine spec 600 delivers value for money with high duty cycle performance of 500 amps @ 60% duty cycle, 20kVA auxiliary AC power with both 240V and 415V outlets and the latest safety features.

Receive 1-3 days from order

The Mine Spec 600 Engine Drive Welder Generator designed for the Mining and Construction Industries.

Fitted with Perkins 404D-22T Turbo diesel engine, Stamford generator and Yunda DC welding inverter.

The advanced technology Yunda DC inverter delivers superior welding performance with easy arc striking, smooth arc characteristics, low spatter and excellent weld appearance. All printed circuit boards potted in resin and encapsulated to prevent exposure to harmful environments.

The Mine spec 600 features five process modes with digital volt/amp meters.

MMA
MMA Cellulosic
Air Arc Gouging
DC TIG
MIG / Constant Voltage Wire

MMA for General Purpose and Low Hydrogen MMA electrode welding.

MMA Cellulosic is optimised for Cellulosic MMA electrode welding.

Hot Start and Arc Force can be adjusted in either MMA or MMA Cellulosic modes.

Air Arc Gouging is optimised to run up to 8mm carbon rods and Strike/Re Strike performance is enhanced by optimised waveform design and VRD response time

DC TIG welding with Lift Arc ignition and gas solenoid valve for optimal control and minimal gas loss. Constant Voltage Wire is

optimised with adjustable inductance for running flux cored wires.

MIG welding with the unique RWS wire feeder, makes it possible to weld Pulse MIG, Double Pulse MIG, Synergic MIG, Manual MIG and MMA from wire feeder.

MINE SPEC 600 Engine drive welder generator Features

Emergency engine stop button located at eye level to quickly shut Mine spec 600 down in case of emergency.
VRD Voltage Reduction Device lowers the voltage in CC MMA and CC air arc gouging modes to below
12 volts in less than 300 milliseconds.
Output at welding terminals controlled by electronic contactor with on/off switch.
Stainless steel enclosure.
Lockable dual pole battery isolation selector for safer maintenance, note: can only be locked in off position.
RCD protection for auxiliary AC power outlets.
Auxiliary AC power with two 240 Volt single phase and one 415Volt IP66 rated outlets
Can be isolated electrically by switching off circuit breakers behind bolted panel.
Weight with fuel/oil/coolant 700Kgs
Internal wiring looms are encased in conduit with rubber boots fitted to avoid mechanical wear and damage.
Drip tray / Roll cage that will contain all liquids used in engine.
IP23 case enclosure.

To contact Arc-i Welding Industries about Engine Driven Welder | Mine Spec 600 use Get a quote.