Suitable for installation in operating theatres, intensive care, recovery wards, isolation rooms, nursing stations, treatment rooms, and other special care areas.
The equipment is suitable for wall mounting in a standard Australian electrical accessory bracket.
The unit is connected to the UPS electrical supply system and will indicate "Mains on" with a green LED indicator.
The unit will indicate loss of supply to the UPS ("UPS in emergency mode") with a synchronised, pulsating, audible alarm and a Visual flashing red LED alarm indicator, The UPSSI is equipped with an audio mute button (the Audible alarm will continue until muted). The visual alarm (and the audible alarm – if not muted) shall continue until the supply is restored to the UPS or the UPS is exhausted.
The mute function can be configured to "time out" if left unattended for periods of 1hr – 4hrs.
The UPSSI can be provided with an optional relay alarm output voltage free contact (normally open or closed on alarm).
Upon total loss of the mains power, the alarm contacts will be in the "Closed Alarm" state.
Power Supply: 100Vac-240Vac, 55mA/36mA Max, 47-63Hz (From UPS)
Fuse Rating: 400mA 250V Slow Blow (F1). Fuse Must be replace with one of the same rating.
Mains Indicator: Green LED indicates mains on
Alarm Indicator: Flashing Red LED indicates UPS in emergency mode
Audible Alarm: Pulsing buzzer indicates UPS in emergency mode
Mute Function: 1hr-4hrs in 1hr increments
Alarm Input: Voltage free contact – normally closed open on alarm
Alarm Output Option*: Voltage free contact (normally open – closes on alarm)
Input Power Connector: Screw terminals suitable for 2.5mm² wiring
Input Alarm Connector: Screw terminals suitable for 2.5mm² wiring
Alarm Output Connector Option*: Screw terminals suitable for 2.5mm² wiring
Operating Temperature Range: 0-55°C
Dimensions: 116mm x 75mm x 30mm (Standard Australian Electrical accessory plate format)
*Must be specified when ordering – additional cost applies
Benbro Electronics | Electronic Equipment Design
Benbro Electronics is an Engineering Based Electronic equipment design and manufacturing facility located in Sydney’s Northern Beaches
We specialise in the design and manufacture of Power supplies, DC–DC converters, Battery chargers, no break DC supplies (Battery Back up Units) and associated equipment for the communications, mining and transport industries. Benbro also custom designs and manufactures other specialist electronic equipment for solar power, emergency services and military applications.
Benbro have the facilities to custom design, prototype and manufacture products to suit your individual needs and welcome your enquiries.