The new structure for the generation of the magnetic field, the innovative route of the signal generated by the electrodes, provide a sensor with an extremely wide measurement range:
EL= Extended Linearity.
This new sensors series follows the successful tradition of the MUT 2200 / MUT 2500, introducing a measurement range of more than 1:1000 without linearization software.
These kinds of performances allow very accurate measures on a wide flow rate range and to count lower flow rates that, before, would have been reset because of the effect of the converters cut off.
This flanged sensors series bases its operation on the Faraday Principle, by which a conductor crossing a magnetic field generates a potential perpendicularly orientated to the same field.
In this case the flow tube made in stainless steel AISI 304 is equipped with carbon or stainless steel flanges, two coils are installed on the top and inferior part; the magnetic field, generated by the electric current crossing the coil, induces in the electrodes a difference in the potential proportional to the flow rate.
With the aim of measuring such potential of very low values, the interior of the flow tube is electrically insulated, thus the process liquid is no longer in contact neither with the material of the flow tube nor with that of the flange.
The converter used generates the current supplying the coil, acquires the electrodes difference of potential, process the signal to calculate the flowrate and administers the communication with the exterior.
The entire sensor, when installed in the separate version, has a degree of protection IP 68 suitable for a permanent immersion in water up to a depth of 1.5m thanks to a welded plate structure containing the coil and the electrodes.
Bintech | Level & Flow Instruments, Pressure & Temperature Gauges
Bintech represents 12 international companies. It is dedicated to supplying quality innovative systems using its vast array of manufactured and imported products, most importantly, personal service to its customers.
Bintech was formed by Michael Bindon in 1993 with only one agency and now has over 12 companies at our dispense to combines technical backup with the ability to adapt products to a client’s specific needs. It is recognised as a preferred supplier for level control products to the oil, gas, LPG and diesel industries.
Bintech offers level measurement devices from 7 different suppliers and 5 different technologies. This enables us to provide the best possible solution to a client’s measurement application or problem.
Bintech has designed and manufactured 2 different systems which have gone on to sell in the thousands.
On-site commissioning and telephone assistance as well as workshop repair, servicing and calibration of our instrumentation can be provided.
The provision of technical support and advice to customers, custom built products as well as problem
solving are important features of Bintech’s business.
Bintech prides itself on its personalised service and attention to detail along with a working knowledge of
each client and their particular requirements.