Loxin Anchors
Loxin Anchors
The Loxin shield anchors are an all steel expansion anchor with a captive threaded nut for use with machine bolts and threaded rod into weaker substrates such as concrete, brick, block and stone.
Loxin
Short length internally threaded expansion anchor.
No special setting tools required.
Able to be used with neat machine head bolts.
General purpose medium duty fixings to concrete, brickwork and block work, in conjunction with bolts or threaded studs.
Can be used on vertical surfaces e.g Brick Walls.
Use when ficture or machine is likley to be moved later.
How to use
- Drill hole at recommended diameter and at least the depth of the anchor. Clean hole thoroughly with a brush;
- Remove debris by way of a vacuum, hand pump or compressed air etc;
- Insert the Loxin net end first until it is flush with the surface;
- Insert the correct size bolt through the fixture into Loxin and tighten.
To contact ITW Proline about Loxin Anchors use Get a quote.
Loxin
Short length internally threaded expansion anchor.
No special setting tools required.
Able to be used with neat machine head bolts.
General purpose medium duty fixings to concrete, brickwork and block work, in conjunction with bolts or threaded studs.
Can be used on vertical surfaces e.g Brick Walls.
Use when ficture or machine is likley to be moved later.
How to use
- Drill hole at recommended diameter and at least the depth of the anchor. Clean hole thoroughly with a brush;
- Remove debris by way of a vacuum, hand pump or compressed air etc;
- Insert the Loxin net end first until it is flush with the surface;
- Insert the correct size bolt through the fixture into Loxin and tighten.
To contact ITW Proline about Loxin Anchors use Get a quote.
The ITW Proline Loxin is a short, internally threaded steel expansion anchor for machine bolts or threaded studs. It requires no special setting tools, so installation uses a prepared hole and the correct bolt. Use it for medium-duty fixing in concrete, brick, block or stone, including vertical brick walls and fixtures or machines likely to be moved later.
- Captive threaded nut stays within the anchor
- Drill to the recommended diameter and at least the anchor’s depth
- Brush the hole; remove debris with a vacuum, hand pump or compressed air
- Insert the nut end first until it sits flush with the surface
Source: listing by ITW Proline on IndustrySearch · Updated 5 Nov 2026
AI Overview is generated by artificial intelligence and may contain mistakes.
Written by AI from the listing by ITW Proline on IndustrySearch. It is meant to use only what that listing says, but it can still get details wrong, so check them with the supplier before you buy.
Thanks for your feedback.
Stainless Steel Roofsafe Anchor Points
Permanently Installed Anchor Points
Surface Mounted & Steel Purlin Anchors
Timber Truss, Chemical & Mechanical Anchors
Wall & Abseiling Anchors
Bulb Anchor Cable Bolts
Anchor Bolts | DYNABOLT
Spyda Temporary Anchor Point
Anchor Bolts - Bolt Anchor
Anchor Bolts | TRUBOLT
Anchor Bolts | LOXIN
Drop In Anchors, Mushroom Head Spikes & Stud for Chemical Anchor
RoofSafe Anchors - Bituminous, Mineral Felt & Other Membrane Roof
RoofSafe Anchors - PVC Membrane Roof
Anchor Point and Strap - Fixing Accessory
Height Safety Anchor Point | Concrete Mount
Anchor Points
Temporary Roof Anchor | SafetyLink TempLink
Anchor Point System | SPYDA | Screw Fix
Reach valuable industrial buyers in minutes
Promote key products & content
Drive cost effective & measurable sales