Span Trusses | Pryda

Read more...

To contact Pryda Australia about Span Trusses | Pryda use Get a quote.

They are ideal for shallower trusses where there is more clearance room to accommodate the plumbing than with timber webs and for trusses where the chord design has some reserve capacity, as is often the case. In some instances, a few diagonal metal webs may have to be replaced by timber webs in these trusses, as load or geometry considerations dictate.

Webs may be on both faces of the truss or just on alternate faces, and in the latter case this allows for the webs to overlap.

Pryda Span trusses are referenced as PS25, PS30, and PS4O, where "PS" means Pryda Span, and "30" is the nominal overall depth (cm). The overall depths are nominally 250, 300 and 400 mm deep. The actual depth dimensions are in nominal size steps according to the metal web used and if required, the specific depth should be obtained from the Pryda licensed fabricator.

Pryda Span is manufactured using light gauge metal webs and are lighter than Longreach, but this is considered during the design process. The metal web system can be very cost-effective, especially if the truss chords have reserve capacity, as is often the case. The nail plates and Pryda Span metal webs are made to exacting standards from Bluescope© steel with a minimum of Z275 corrosion protective Zinc coating.

Product Benefits:

Pryda Floor Truss Systems offer many benefits to the designer, the builder and the building owner in providing a reliable high performance system for both domestic and commercial construction. The use of the Pryda Floor Truss System results in a very cost effective, high quality product that is sufficiently flexible to accommodate the most complex of building requirements.
 

Read less...

To contact Pryda Australia about Span Trusses | Pryda use Get a quote.