WIA Wire Feeder | 350I & 500I

WIA - Wire Feeder | 350I & 500I

Supplier: Wess

Wire Feeder | 350I & 500I

SUITS WELDMATIC 350I & 500I

In Stock

Weldmatic W65 Wire Feeder

4 Roll Drive 80W Motor
Provides a consistent, strong drive for a variety of wires.
Heavy Duty 4 Roll Drive
System has improved large stronger drive gears and ball bearing on drive rollers and shafts.
High and Low Speed Range
Provides 1 to 10m/min or 8 to 20m/min speed, giving finer control of wire speed – particularly useful at lower voltage settings.
Arc Start Control
Allows starting response to be fine-tuned to weld conditions.
Creep Start Mode
Provides slow wire speed until weld starts - ideal for aluminium starts.
Purge
Allows gas line to be purged, without feeding wire.
Inch
Allows wire to be fed without wasting gas.
Latch
Press and release gun switch trigger to start and then again to stop, reducing operator fatigue on long welds.
Pre Gas
Allows gas to flow before weld starts.
Post Gas
Allows gas to continue flowing after weld has finished.
Spot Time
Provides short weld times for repetitive spot welds.
Burnback
Controls how far the wire burns back to the tip on completion of the welding operation.
3 Year Gold Shield Warranty
Every Weldmatic machine is backed by WIA's industry leading 'Gold Shield 3 Year Warranty', covering parts and labour, and supported by an Australia wide service network. For details, refer to the Weldmatic warranty statement.

To contact Wess about WIA Wire Feeder | 350I & 500I use Get a quote.

Weldmatic W65 Wire Feeder

4 Roll Drive 80W Motor
Provides a consistent, strong drive for a variety of wires.
Heavy Duty 4 Roll Drive
System has improved large stronger drive gears and ball bearing on drive rollers and shafts.
High and Low Speed Range
Provides 1 to 10m/min or 8 to 20m/min speed, giving finer control of wire speed – particularly useful at lower voltage settings.
Arc Start Control
Allows starting response to be fine-tuned to weld conditions.
Creep Start Mode
Provides slow wire speed until weld starts - ideal for aluminium starts.
Purge
Allows gas line to be purged, without feeding wire.
Inch
Allows wire to be fed without wasting gas.
Latch
Press and release gun switch trigger to start and then again to stop, reducing operator fatigue on long welds.
Pre Gas
Allows gas to flow before weld starts.
Post Gas
Allows gas to continue flowing after weld has finished.
Spot Time
Provides short weld times for repetitive spot welds.
Burnback
Controls how far the wire burns back to the tip on completion of the welding operation.
3 Year Gold Shield Warranty
Every Weldmatic machine is backed by WIA's industry leading 'Gold Shield 3 Year Warranty', covering parts and labour, and supported by an Australia wide service network. For details, refer to the Weldmatic warranty statement.