The COALSCAN Model 9500X monitors the full flow of coal without the need for routine samples to be taken and analysed.
The COALSCAN Model 9500X provides real time information, with updates typically every two minutes, as well as cumulative averages for the current hour, shift or shipload.
This premium technology provides real time analysis of the important coal quality parameters for process control. The analyser is fully contained in the single, heavily shielded enclosure that contains the radioactive source, gamma-ray detection assembly and all electronics. Industry standard communication outputs are available for interface with any plant control system or with Scantech's SuperSCAN output display system installed in any suitable remote location.
COALSCAN Model 9500X Applications
Real time elemental analysis provides active control over coal quality, with timely information on ash, moisture, sulphur, energy content and elemental analysis to make decisions that optimises process control, maximises the value of the resource and minimises operating costs.
COALSCAN Model 9500X Technology
COALSCAN Model 9500X incorporates a proprietary detector array giving a better spectrum by allowing simultaneous detection in the individual detectors. This compound array overcomes the limitations of conventional, low efficiency detection systems. The COALSCAN Model 9500X spectrometer can operate at much higher count rates than conventional systems, with lower pulse pile-up. This innovation vastly improves the signal to noise ratio and spectral peak resolution.
COALSCAN Model 9500X Online Coal Ash and Moisture Analyser Advantages:
- Ultra-compact design. Uses only one metre of belt space and installs between standard idlers
- State-of-the-art technology
- Suits most belt sizes and loads
- No contact with the material or the conveyor belt
- No sampling necessary during normal operation
- Low maintenance cost
- No wearing parts
- Optional customised software output using SuperSCAN
- Interface to a wide range of process control systems
- Remote and local technical support
The COALSCAN 9500X provides continuous monitoring of the standard coal analyses Ash, Sulfur, Specific Energy / Heating Value and Moisture.
In addition, the COALSCAN 9500X can monitor and report the major oxides in ash, such as: SiO2, Al2O3, Fe2O3, CaO, MgO, Na2O, K2O, TiO2, MnO2, SO3, and Cl depending on concentration.
For your peace of mind we can offer you Free Testwork on your Samples to asses the suitability of the technology to each application. This removes any concern over buying a system where performance for your application would otherwise be uncertain.
We provide money back performance guarantees on our analysers.
To find out more about the COALSCAN 9500X Online Coal Ash and Moisture Analyser please call or use the IndustrySearch email form for a direct reply.
Read less...
Need more information? Message Scantech International via the form, or call and say you found them on IndustrySearch so they can best assist you.
-280x280-state_7.jpg)
