Weatherproof Totaliser | C04HWP

Read more...

Need more information? Message Innovec Controls via the form, or call and say you found them on IndustrySearch so they can best assist you.

The CO4HWP four digit LED Totaliser is a 120/240 VAC or 18-36 VDC powered microprocessor based totaliser that incorporates a four (4) digit 100mm digit height LED display in a weatherproof surface mount enclosure. It has dip switch selectable input for, CMOS logic, open collector transistor, reed switch, hall affect and turbine meter (20mV peak to peak minimum).to produce a total in the units of your choice using a field programmable K factor.

Features:

• Memory retention in power down for 10 years
• 85 to 265VAC 47-63 Hz supply or factory fitted 12 to 36vdc isolated supply
• Contact bounce elimination circuitry
• Microprocessor based
• Low cost – High performance
• Flow totalise
• High contrast LED display
• The C04HWP has a 4 digit 100mm digit height LED display
• Surface mounting IP65 weatherproof enclosure
• 24VDC transducer supply
• Touch switch programming of decimal point and k factor

They incorporate field programmable totalising rates and a 24 VDC isolated supply for powering remote sensors. The CO4HWP is supplied in a surface mount IP65 weatherproof enclosure. Screw terminal electrical connection is included.

Specifications:

• Input Details
  • The instrument counts input pulses and displays the totalised value on a four (4) digit LED display. The input is dip switch selectable for dry relay contact, open collector, turbine meter, reed or proximity switch and CMOS logic
  • CMRR greater than 86db
  • NMRR greater than 100db
• Display
  • Four (4) digit 100mm digit height high contrast light emitting diode (LED) with a wide viewing angle and a viewing distance of 20 metres
• Decimal Point
  • Programmable from the front panel to display units or 0.1 units.
• Count Integrity
  • Contact bounce elimination circuitry enable error free counting even in the most difficult application. The count is stored in eeprom.
• Remote Reset
  • By connecting a normally open push button between terminals 1 and 6.
• Environmental Parameters
  • 0-70 degrees Celsius
  • 0-90% rh non-condensing
• Instrument Power Supply
  • 120/240VAC 47-63 Hz or DC to DC converter isolator from 5 to 48VDC
• Transducer Power Supply
  • A 24VDC at 30mA transducer power supply is incorporated in the instrument.
• Weight
  • 300 grams
• Mounting Details
  • Surface mounting weatherproof enclosure of case dimensions 380mm wide by 190mm high by 130mm deep with fixing centres of 355mm wide by 164mm high.
• Calibration
  • The decimal points and k factor are programmed by the front touch buttons and the values are stored in eeprom.
• Ordering Information
  • Model number configured as: Model/input signal/display units/power supply/options
  • Sample number: C04HWP/CC/0-9999/VAC

Read less...

Need more information? Message Innovec Controls via the form, or call and say you found them on IndustrySearch so they can best assist you.